door seals and other seals

[sexa]

Hey guys, i need to get my door seals replaced as some water leaks in from the top of the window on the passenger side ande targa/door seal on the drivers side, do you know where i can go to get these replaced, im from canberra but sydney is ok if not there where else? is it expensive and can i replace them myself? also my boot seal is torn and seing as its on its way to being a show car i need that replaced to cause it looks bad, its the actual rubber seal about an inch or so inside the boot, thanks, any suggestions are great!!
:hitwall:

[DEVILsEXA]

If u end up going to tha wreckers and find some... get a spare drivers side door seal for me, i'll get ya to send it over! I dont mind paying anything under say $50

but then it depends on what they are worth

I NEED ONE!!!


Cheers,
Craig.

[Used2B]

Ive heard they are expensive..
some 500$ for the set or something rediculous coz its a continuous rubber that goes from the bottom of the window all the way round the targa and back down

thats y i checked mine didnt leak b4 i got it..

[Blood]

i believe that it was LONZ that suggested this :-

Try adjusting your window.. so thast it is about 5mm higher...
to make it a better cushion / seal

[DEVILsEXA]

well my drivers side door seal (sepperate) has torn!!!

:(

so NOT good

[Nugget]

my drivers side door leaks. but the seal looks brand new, looks like the window in 5mm to short how do raise to window up?

[Blood]

i have never actually done this myself... but i need too ! :nasty:

Undo the interior of the door (door panel ? )
and it will be on the inside somewhere ..

possibly the 2x 12mm nuts with kinda like a screw in the middle of the nut, u will need a pair of pliers to get it ..

as i said, i havent actually done this... just my idea

[BENRYS]

yeah i went to nissan.... if u want a laugh go there... i went about 10 months ago

somehting like 600 for every seal on one side... somehting stupid... go to clark rubber, they'll match it...

[sexa]

so can someone take me through getting my doort panel off correctly and properly, i have tried to take it off b4 but broke a screw almost immediatly and put it straight back on for fear of wrecking it...so could anyone reply with like a walkthrough on it, id say that there are a lot of exa owners out where that could do with the info. not just for windows but for stereo stuff as well
thanx

[DEVILsEXA]

*check stereo section*

theres a step by step in there allready! ;)

Craig.

[sexa]

oh shit so thats just in our normal manual? thanks. The nnnns that indstalled my alarm snapped wanna the screws and i had to glue the fuckin door back on, looks queer now