Got Boost??

[BoOsted]

Hey guys,
I'm at work, and so f*ckin bored!!! so i thought i'd go check the N12 board..... and there's Jack-squat here!!!
so here's sumthing you all should answer as long as ur turbs isn't stuffed...

What turbo and what psi?

K, i start, and i expect lots of posts!!

GT28 ball bearing on 15psi

.....till microtech arrives!! there should be no holidays for car parts suppliers

i'll post back with microtech in and tuned.

Dan

[boostinhard]

Hey,
yah - there aint much here at the moment as we just lost all our previuos posts thanks to bugs in the system

Yeah, I got boost. T04 @ 20 psi. Microtech allready in... lol. GT28 hey,
nice turbo - what modle out of the gt28's is it AR ratios?
Sam

[chris2]

got a shitty little T28, running, wait for it- monsterous 6.7psi with MT8
can only get to 12 as well, ceramics- great for kitchen wares
hopeless as a turbine!
.48exhaust
.53inlet

its off a 300zx twinturb.

[BoOsted]

Its from an S15 and brand new... cost $1550.


.64 Exhaust & .60 Compressor. I'll run 20psi too when microtech is in, runs lean on 12psi. i went to this place for dyno, and they told me 71kw... and it needs a haltech, and what a surprise, they supply haltech!! i told them to go blow themselves and i'm gettin it done somewhere else with a microtech ( they said microtech are shit...)

Good to see u'll be in adelaide soon sam,
I may have a front seat for ya on the cruze, but not sure, my women takes priority (she makes me make her priority ) but let me know!

i'll try to get microtech in and tuned by then!

Dan

[boostinhard]

Hey,
yeah there's nothing wrong with microtech or haltech... Personally I'd pick whatever you (or your fav tuning shop) are familiar with.
Ah, the s15 200sx t28... To be picky, its not really a garrett "GT" series turbo, but very similar as it is a dual ball bearing, late design garrett turbocharger... Should be able to put out some serious power with that turbo - I beleive its the turbo of choice if you want power thrououth the entire rev range... Yeah, I'll be heading over to adelaid, but I'll settle for a ride in the backseat of an N12 If you havent removed yours like me!) after sitting in the backseat of an n13 for 8 hours!!! lol...
got any pics of your beast?
Sam

[85EXABOY]

i have a monster t25 pushing 10psi through the stock non boosted t2 wastegate hehehe.. not quite a monster

btw i am heading up to sydney tomorrow arvo and then to melb on the 10th.. hopign to catch some of the interstate cars out crusing while im there.

ohh also have some bad news, as soon as i find a suitable car for my sister im selling the exa to pay for it. Under a deal i did with my parents theres a cefiro with my name on it coming into australia later this month and i cant miss it. its straight, black and most importantly has a rb20det under the bonnet weehehehe

[boostinhard]

Hey,
yeah? Will you have time for a cruise while your down here You flying or driving down? Im sure we can do something while your in the hood! The 10th till what? I have to pay my redgo on the 10th - so I'll e kinda broke... Its kool, I'll find a source off a $100 for a week when I got a monster paycheck comming (well for me its a big one!!!, All $280 of it.... ) But, I think a cruise is definatley on the cards for an interstate traveller... Will be mostly N13's though - as none of these damn N12 drivers are up for cruising (part fomr me!) but I know a few done here and will try to russle them up for you!
Sam

[Android 360]

still dont have the n12 but im in the process of purchasing an n13 for a daily driver...

in terms or turbochargers, the closest i got is a hairdryer.. what psi do they put out?? it has a high output mode as well

[chris2]

we put a ronson hairdryer (no heat) on a victa at idle, got increase in RPM, we still had it hooked up to 240v so anyting after idle died!!!!

[Nisman]

running a t25 and 18psi with ems management.

did run 25 by mistake the other day, and it ripped, but unless i get it properly tuned it wont go back that high.

the only reason i got a t25 was everyone i knew with e15s told me a t28 was too big, but im kicking myself now

i am actually having probs with my turbo again and its under warranty so if he will replace it, he might do me a t28 instead .... fingers crossed.

Paul.

[BoOsted]

hey

-Sam - backseat would've been fine, but she's decided that the adelaide skyshow is more important so its all yours!
And u've seen all the pics i've got i reckon, red 84 wit ET mags, new engine, new turbo, really low! (my pc broke so haven't been on msn or anythin for ages)

Thats no good that ur sellin the exa hieu! reckon u'll still have it for the cruise? or make it a condition of sale that they come on the cruise!!

Dan

[boostinhard]

Hey,
sweet- consider the seat taken... Tell her to be carefull though - I aint ever going to an airshow!!! Thsoe damn things are so dangerous! there must be atleast one ting on the news a week about a plane killing like 30 people at an air show somewhere in the world...

And Heiu - yeha, try and hangon to her for a bit longer as I just have to see an N12 witha cooler that size with some real tasty rims in the flesh - I just have to!

Paul, yeah a t28 would have been abit more fun, mind you, if you can get the t25 to hit its peak efficiency througout more of your rev range, you have to come up trumps around town...
Sam

[KAMELEON]

at tafe we hooked up a "additional" heater/cold air blower to the top of the carbie on a mates gemi
blowing 3psi it really went alot harder
but only on the cold setting

[boostinhard]

Hey,
hehe - I wanna see someone install one of those Electric turbochargers - the ones that has the demo video file, that when the guy turns it on - it has enough force to lift itself off the ground and up, up and away!!! thats some power!!! $600 from EKW... Pricey, thats why I want someone else to do it - I jsut wanna see if it actually makes that much difference on an NA car...
Sam

[EXA ACE]

Shit fellers i dont want to go cruzin with yous now you all got BIG STUFF and i got me a sweet stocko garret t02 man ive seen bigger rice crackers than my turbo and its got a monstrious 7psi of boost look out ha ha not even later guys REECE

[EXA ACE]

AND IM NOT A EXA NEWBIE

[[YMMIJ]]

T25 with 9psi, 3psi of which is due to boost creep, but it's fine with me!

hey exaboy , you've helped me alot durring the last 3-4 years. I think it's time i saw you in person. Give me a holla when you get down here. We'll hit the drags or something. My new car gets all the challenges. Turns out it's running a T04 with 9psi boost, which is creeping from 6.5. Made 167kw at the rears! Too bad on our first criuse to the drags i blew a tyre and get canned by commos with this shitty aluminium wheel on.

[boostinhard]

Hey,
whats your new car?
Sam